Kenmore 11081860110 Washing Machine That Fills, Spins and Drains but Will Not Agitate

Here is a transcript of a recent online posting of a Kenmore washing machine repair issue from the Appliance Zone Repair Forum. Hopefully it will give you some guidance if you have the same issue. For any other repair questions make sure to check out the Appliance Zone Repair Forum!

Question:

We have a Kenmore 11081860110 that fills, spins and drains but will not agitate.
In Agitate area of dial (any agitate area) Motor does not run but timer ticks.
I'm also having trouble reading the wiring diagram.

Tech:

Thank you this could be two things ,either a timer contact internally in the timer .
Or the drive motor itself .
for agitation it turns one way for drain and spin it turns the opposite way .
you would have to measure voltage to the motor to see which it is.

Question:

I think the motor is fine.
Here are the motor resistance readings with harness disconnected:

Motor Harness
Open GRN
W W
NoPin Open
NoPin Open
Open RED

Meter Resistance
PROBE PROBE 0.3
Motor
W BLU 1.5
W W/BLK 0.3
YEL RED 7.6

BLK YEL 7.6

BLK W >20M
BLK W/BLK >20M

I remember *somewhere* reading that for a direct drive if you swap 2 wires and put it in
"SPIN" then it should agitate, (assuming it spins in the normal configuration). I haven't found
that *somewhere* again. Would this work as a test?

Also on the distorted, difficult to read wiring diagram I have (3351735) I assume the #s
next to the switches are the timer positions and that the lack of odd "SW. Function's was
for "readability", is that correct?

I suspect the timer (3951734) since I hear no 60Hz from the motor in the agitate mode.

I have the tub filled enough to run on low level.

In the "Cotton/Sturdy" mode I suspect I should see low resistance across the power plug in the agitate mode as I do in the spin state.

Resistance across plug
Cotton/sturdy spin 1.8
Permanent Press spin 2.28K
Delicate spin 2.28K

After spraying timer with contact cleaner
Resistance across plug
Cotton/sturdy spin 1.8
Permanent Press spin 2.25K
Delicate spin 2.25K

Cotton/sturdy agitate 2.25K
Permanent Press spin 2.25K
Delicate spin 2.25K

Tech:

Just go down to the motor at Yellow and Red with the unit in an agitation mode check for 120 volts A/C if you have voltage it the motor if no voltage it is the timer 1

Question:

There is a momentary jump on the DVM set at 200VAC then returns to 0.00.
Based on this I'll get a new timer and post the resolution here.

Tech:

Yes that sounds like the issue .good luck